How To Fix Dents in Wooden Floors & Furniture

Birch 2.jpg

Many years ago a teacher told me that you could steam out a dent in a piece of wood (one where the wood fibers had been compressed, not a where they had been removed) using a wet rag and an iron.

This technique was meant for unfinished wood, but unfortunately, most of the wood we deal with in our homes has some sort of finish on it. With some research I learned that this technique can work with finished wood but it depends greatly on the type of finish you are dealing with. So I decided to do a couple of tests to see the results for myself.

NOTE: BE CAREFUL! SOME FINISHES MIGHT TURN WHITE WHEN EXPOSED TO STEAM. PLEASE TRY THIS IN A HIDDEN AREA BEFORE DOING IT IN A VISIBLE PLACE.

The first test was a on a birch table from IKEA. Although this technique works better on new dents I decided to try to steam out a dent that had been there for quite a long time.

Here is what was done:

1. Wet the dent
2. Apply a wet cloth or paper towel
3. With the iron on High apply the iron to the wet paper towel or cloth and make a circular motion, don’t keep it in just one position as this might burn the surface of the towel. Make sure there is a lot of steam being generated. Do this for a few minutes and check your results. In my case I did this for about 3-5 minutes.

Birch 1.jpg
Birch 2.jpg
Birch 3.jpg
The dent came up almost completely and there was no damage to the finish!

My second test was on our hardwood floors. I found a dent that was pretty deep. I followed the same steps as above.

Oak 1.jpg
Oak 2.jpg
Oak 3.jpg

Although the dent came up, the surface of the finish had been broken and some dirt had gotten in side the cracks. If you know what type of finish you are dealing with you might want carefully sand the area and reapply the finish.

Oak 4.jpg

In the spirit of this experiment I tried sanding and got most of it out. Then I applied some Tung Oil that I had at home. It’s probably not the same as the original finish but the area certainly looks better than before. Here is my result:

Oak 5.jpg

Has anyone else given this method a try? Have any other fixes to recommend? Please share your smarts in the comments…
(Source: apartmenttherapy.com)

Share this!
Share On Facebook
Share On Twitter
Share On Google Plus
Share On Pinterest
Share On Reddit

Leave a Reply

Your email address will not be published. Required fields are marked *